Curve Pull, Solid Brass Edge Pulls
- $16.00
- $16.00
Curve is an ageless, gracefully designed brass cabinet edge pull.
- This product is not available in brick and mortar retail stores.
Perfect for:
- High use areas
- Kitchens, bathrooms, furniture
Materials and Finishes:
- Solid brass with satin brass finish.
Dimensions:
- H: 0.8" L: 2.4" C-C: 1.6"
- Tear sheet available here.
Important fit measurement:
- The back is 7/8" high (where it attaches to the cabinet)
Included:
- 2 cabinet screws (1/2" length)
Shipping:
- Ships within 2 business days from Seattle, Washington
Shop with Confidence!
- If you don't love the item simply return it.
- See our comprehensive return policy here .
Need samples?
Installation Instructions (click here) or see below:
- For new installations, pre-drilling holes is required . Important Note: If you do not pre-drill holes, you risk the screws snapping inside the cabinet. Inspire Hardware is not responsible for any installation issues if these installation instructions are not followed.
-
Steps:
- Place the edge pull on the cabinet where you would like to install them.
- Once you’re happy with placement, from the back of the cabinet door or drawer, use a pencil to mark the screw holes. If you don’t want to mark up your cabinet, you can use a piece of painter’s tape in the area where the screw holes will go, and make the marks on the painter’s tape.
- Take your drill and 3/16” drill bit, and set the bit to the depth of the screws provided.
- Use the drill to pre-drill holes into the back of the cabinet, taking care not to drill through the front.
- Once the pilot holes are drilled in the correct spots, place the pull in the correct spot with the holes aligned.
- Use a screwdriver to tighten the screws into the cabinet. If using a drill for the step, there are risks to stripping the screws or snapping them in the cabinet, therefore it is recommended to use a screwdriver.
- Stand back and enjoy your new hardware!
-
Share -
Tweet -
Pin it